- Sports goods test class
- Auto test instrument
- Rubber and plastic testing instrument
- Testing equipment in various industries
- Photovoltaic physical properties test equipment
- Add: No12. aiy .115,ln 235 Fuyang rd Fengyuan dist Taichuang city 420 Taiwan
- Tel: +886-4-25254837
- Fax: +886-4-25254837
- Email: sales@mytech.tw
MY-2906-S Car seat angle durability testing machine
- Product description: 一. ) Function and standards： 二. 1. car seat recliners durability test, after completing the set actuation frequency observed recliner wear, determining quality. (Small passenger seatback recliner tec
Product introduction
-
) Device is equipped with the parameters:
- Servomotor : 2.5 KW .
- Load cell: 500KG two set (load cell means to the floor immediately below, after which the resulting power source through trigonometric functions and Fourier FFT function calculates the beginning of the measurement of resistance).
- rod load cell: 100KG
- Planetary Gearhead
- simulate the human body back die tree set
- Arm Material: Aluminum combination
- Large control cabinets 19 "LCD screen, computer-controlled, Dedicated software controller
- 8. infrared device (H point)
9. The test platform can be raised and lowered, with the H-point adjustment
三.) Action Requirements：
1. Angle adjustment is set, the action is set to 10 segments, each set dead time (0 ~ 10sec). Recliner handle to lift simulate passenger operating mode ‧
2. Seat angle durability testing machine (manual)
3. Action sequence: first tooth → last position → neutral position → foremost position as a loop operation number: 10000 loop (available for power tracking, range, frequency adjustable)
4. Pause function: the test halfway need to pause to check sample
5. Control: computer servo control, servo motor drive, spindle test machine, maturity structure, sensor trigonometric calculations,FFT Fourier function calculation, may from time to time to read and record each rotation and drawbar force value and angle of the curve,Curve and pull the lever and stroke.
6. Test procedure programming mode (the computer can define your own test sequence).
(1) back from the most anterior segment → → final design position as a cycle, arbitrarily set the number of cycles within the range 0-999999.
(2) back by the first paragraph of the preceding → LOCK position → most front position is a cycle, arbitrarily set the number of cycles within the range 0-999999.
(3) back from the first paragraph of the preceding → LOCK position → position → the last paragraphs preceding position as a cycle, arbitrarily set the number of cycles within the range 0-999999.
7. Test speed 1.3 ~ 1.5 m / sec (600mm above the fixture to the back of the center of rotation is applied)
四.) other requirements：
1. Power : AC 3Ø, 220 V, 50/60 Hz
2. Countertops 150x100 cm.
